| Belt Guiding
The Fife Belt Guiding Systems increase board accuracy into the slitter/scorer and assure exact centerline alignment of continuous belt lines. This results in improved board quality with less belt fatigue because of lateral repositioning of the belt is restricted to the amount of error detected as opposed to the full stroke lateral movement of the typical “on-off” limit switch guide system.
The system provides exact alignment of the continuous belt by using a closed-loop, fully proportional system. The D-MAX Series Web Guide Controller works as a closed-loop system detecting edge and center guide information from the DAC-004 Diode Array camera sensor and directing the guide structure to make the correct alignment adjustments prior to the slitter/scorer function.
Key Features:
- Fully automatic. Operator attention not required
- Virtually maintenance-free, protected from dust, condensation, other contaminates
- Easily installed on existing belts.
- Eliminates need for “on-off” control system or mechanical side guides which harm the belt.
More information
BACK
|
|
 |
